Wishlist
Ski-doo Gen4 850 Products There are 4 products.
Subcategories
AvailableG4/G5 Brace addition
This brace piece comes in our g4 brace kit and bundle kit. Sold separately for customers that had bought our kit before we included this new piece. This is a new brace addition to our G4 brace kit. A new piece to further strengthen the front end of the G4. Made from stainless steel and replaces the stock aluminum piece.
This brace piece comes in our g4 brace kit and bundle kit. Sold separately for...
This brace piece comes in our g4 brace kit and bundle kit. Sold separately for customers that had bought our kit before we included this new piece. This is a new brace addition...
AvailableTool Caddy
Fits nicely in the rear seat or the glove box. A quality hard zippered case includes the following:8, 10, 12, & 13 mm wrenches.30 inch telescoping magnet with 20 lb. lift capacity.20 - 8 inch zip ties.15 foot roll of duct tape.1/4 inch ratchet.1/4 inch Driver.1/4 inch T25 & 40 torx sockets.1/4 inch phillips & flat tip sockets.1/4 inch universal joint.The Torx sockets fit many of the screws used on...
Fits nicely in the rear seat or the glove box. A quality hard zippered case...
Fits nicely in the rear seat or the glove box. A quality hard zippered case includes the following:8, 10, 12, & 13 mm wrenches.30 inch telescoping magnet with 20...
AvailableQRS Ratchet Wrench
QRS Ratchet Wrench is perfect for changing the helix, spring or secondary rollers in the 2008 to current ski doo secondary clutches without the need to remove your secondary clutch/shaft. The wrench is just over 12 inches long and has a ratchet on each end. The end is 12 mm. The opposite end is 13 mm. The wrench includes a T-40 torx bit that will not fall out of the wrench.
QRS Ratchet Wrench is perfect for changing the helix, spring or secondary rollers in...
QRS Ratchet Wrench is perfect for changing the helix, spring or secondary rollers in the 2008 to current ski doo secondary clutches without the need to remove your secondary...
AvailableTorx Bit for QRS...
The T-40 Torx Bit works perfect for removing the 4 torx bolts that hold the helix in place on all QRS Secondary Clutches. Fits all 6 point & 12 point - 12 MM wrenches and sockets. The Torx Bit has a tension ball that holds it firmly in the wrench or socket. Will not fall out. This bit is used for changing secondary rollers, helix and spring without the need to remove the secondary shaft. NOTE: Wrench shown is not included, but can be...
The T-40 Torx Bit works perfect for removing the 4 torx bolts that hold the helix in...
The T-40 Torx Bit works perfect for removing the 4 torx bolts that hold the helix in place on all QRS Secondary Clutches. Fits all 6 point & 12 point - 12 MM wrenches and...
